NEW!HOT!

Recipes without the life story, the pop-ups, or the 12-paragraph preamble. Since 1996.

Recipe Zone

Hand-typed HTML · No cookies · No pop-ups · No fluff

✉

Cast-Iron Pan-Seared Steak

Filed under its category

Photo Coming Soon!

No photo yet. No stock image, no 40-shot gallery either.

(Still under construction — thanks for your patience.)

Dry-brined, seared hard in tallow, then finished in foaming butter and aromatics — a steakhouse crust without a single drop of plant oil.

Recipe Facts

Prep Time15 min
Cook Time15 min
Total Time30 min total
Servings2 servings
DifficultyMedium
Date AddedSeptember 22, 2026

Ingredients

  • 2 steaks, 1½-inch / 4 cm thick (about 1 lb / 454 g each) — ribeye, New York strip, or sirloin
  • 2 tsp / 10 g kosher salt, for the dry brine
  • ½ tsp / 1 g coarse black pepper
  • 1 Tbsp / 14 g beef tallow (or ghee)
  • 2 Tbsp / 28 g butter
  • 2 cloves garlic / 6 g, smashed and left in the skin
  • 3 sprigs fresh thyme
  • 1 sprig fresh rosemary
  • Flaky salt, to finish

Step-by-Step Instructions

  1. Step 1: Dry-brine. Pat the steaks dry and season all over with the kosher salt — about 1 tsp / 5 g per steak. Set them on a wire rack over a plate and refrigerate, uncovered, at least 1 hour and up to 24. The salt seasons the meat and dries the surface, which is what makes the crust.
  2. Step 2: Temper and dry. Pull the steaks 30–45 minutes before cooking so they come toward room temperature. Pat the surface dry again with paper towels and season with the black pepper. A wet surface steams instead of sears.
  3. Step 3: Heat the pan. Put the skillet in the oven at 450°F / 230°C for 10 minutes, or heat it on the stovetop over high 5 minutes, until a drop of water evaporates on contact. Add the tallow and swirl to coat.
  4. Step 4: Sear the first side. Lay the steaks in the pan and do not move them. Sear 2–3 minutes, until a dark brown crust forms and the meat releases on its own.
  5. Step 5: Flip and start the baste. Flip the steaks and sear 2 minutes. Add the butter, garlic, thyme, and rosemary. Tilt the pan slightly and spoon the foaming butter over the steaks continuously for 1–2 minutes.
  6. Step 6: Check the temperature. Insert an instant-read thermometer into the center from the side. Pull the steaks 5°F / 3°C below your target, since they carry over as they rest.
  7. Step 7: Rest. Move the steaks to a rack or warm plate and rest 5–10 minutes for a 1½-inch / 4 cm steak. Resting lets the juices redistribute instead of running out on the board.
  8. Step 8: Slice and finish. Slice against the grain, sprinkle with flaky salt, and spoon over any resting juices.

Cook's Notes

  • Serves 2 | 12-inch / 30 cm cast-iron skillet
  • Doneness temperatures (pull 5°F / 3°C below target)
  • Rare — target after rest 125°F / 52°C, pull from pan 120°F / 49°C
  • Medium-rare — target after rest 135°F / 57°C, pull from pan 130°F / 54°C
  • Medium — target after rest 145°F / 63°C, pull from pan 140°F / 60°C
  • Medium-well — target after rest 155°F / 68°C, pull from pan 150°F / 66°C
  • Well done — target after rest 160°F / 71°C, pull from pan 155°F / 68°C
  • Thicker or thinner steaks: adjust by feel. A 1-inch / 2.5 cm steak needs about 2 minutes per side; a 2-inch / 5 cm steak needs 3–4.
  • Reverse sear for thick cuts: cook the dry-brined steak at 250°F / 120°C until it reads 10°F / 6°C below target (about 30–40 minutes), then sear hard in tallow 1 minute per side and baste with butter. The edge-to-edge pink is more even.
  • If you skip the dry brine, salt right before searing and expect a slightly less developed crust.
  • The searing technique here is the base for beef-wellington.md and works on the short ribs in beef-ribs.md.

Rate This Recipe

Not rated yet

Your vote:

Visitor Comments (0)

No comments yet. Be the first — keep it short.

Leave a Comment

← Back to all recipes